How it works: Antenna

Range is often decided by the antenna.

Off the grid, a LoRa sensor's data travels through the air for kilometres at 868 MHz. An antenna's type, height and position decide whether that data reaches the gateway.

What an antenna does

An antenna puts the sensor's signal into the air and takes it back out at the gateway. What matters is where that signal is directed.

Gain does not make energy, it directs it

Two ideal antennas fed with the same power. The array gathers its power towards the horizon, and in return radiates almost nothing in some other directions. So the highest gain is not the right choice on every site: a gateway high on a mast may not hear the sensor right below it.

Vertical radiation pattern, upright antenna
  • Half-wave dipole
  • 4-element array
Rings: gain (dBi)
-10 dBi0 dBi10 dBi0°, straight up90°, horizon180°

At the horizon the dipole gives 2.15 dBi and the array 6.42 dBi. At 30° above the horizon the dipole gives 0.39 dBi while the array radiates almost nothing.

Calculated values: an ideal, lossless half-wave dipole, and four of them fed in phase and spaced half a wavelength apart.

What we look at when choosing an antenna

  1. Frequency

    An antenna is chosen for the band in use. On the wrong band it reflects power back instead of sending it out.

  2. Gain and pattern

    Are the sensors spread around the gateway, or gathered in one direction? The radiation pattern is chosen to match.

  3. Height and line of sight

    Buildings, trees and terrain block the signal. Raising an antenna often helps more than adding power.

  4. Cable and connectors

    Every metre of cable and every connector between antenna and device takes some signal, and that loss is counted.